基于ADP8863設計的帶電荷泵驅動的LED驅動技術
時間：2010-08-06 23:05:25
關鍵字：
電荷泵
LED驅動
驅動技術
AD
手機看文章
掃描二維碼
隨時隨地手機看文章
[導讀]ADP8863具有先進的自治的LED光特性的功1強大的電荷泵驅動器,能獨立地驅動多達7個LED,每個電流高達30mA,第7個LED的驅動電流可高達60mA.電荷泵的自動增益選擇有1x,1.5x 和2x,工作電壓從2.5 V 到5.5 V,可驅動最大電流24
ADP8863具有先進的自治的LED光特性的功1強大的電荷泵驅動器,能獨立地驅動多達7個LED,每個電流高達30mA,第7個LED的驅動電流可高達60mA.電荷泵的自動增益選擇有1x,1.5x 和2x,工作電壓從2.5 V 到5.5 V,可驅動最大電流240mA,主要用在LED指示器,裝飾指示照明,鍵盤照明,RGB LED色彩發生和藹混合以及小型顯示器通用照明.本文介紹ADP8863主要特性,詳細方框圖以及多種應用電路.
The ADP8863 combines a powerful charge pump driver with advanced autonomous LED lighting features. It allows as many as seven LEDs to be independently driven up to 30 mA (maximum). The seventh LED can also be driven to 60 mA (maximum). All LEDs are programmable for maximum current and fade in/fade out times via the I2C interface.
Additionally, automated blinking routines can be independently programmed and enabled for all seven LED channels. These LEDs can also be combined into groups to reduce the processor instructions.
This entire configuration is driven by a two-capacitor charge pump with gains of 1×, 1.5×, and 2×. The charge pump is capable of driving a maximum IOUT of 240 mA from a supply of 2.5 V to 5.5 V. The device includes a variety of safety features including short-circuit, overvoltage, and overtemperature protection. These features allow easy implementation of a safe and robust design. Additionally, input inrush currents are limited via an integrated soft start combined with controlled input-to-output isolation.
The ADP8863 is available in a compact lead frame chip scale package (LFCSP).
ADP8863主要特性:
Automated blinking and funlight timing for each LED driver
16 programmable fade in and fade out times
0.1 sec to 5.5 sec
Selectable linear, square, or cubic fade rates
7 independent and programmable LED drivers
7 drivers capable of 30 mA (maximum)
1 driver also capable of 60 mA (maximum)
Programmable maximum current limit (128 levels)
Separate and independent controls for backlight LEDs
Backlight fade override
Up to two built-in comparator inputs with programmable modes for ambient light sensing
Charge pump with automatic gain selection of 1×, 1.5×, and 2× for maximum efficiency
Standby mode for <1 μA current consumption
I2C-compatible interface for all programming
Dedicated reset pin and built-in power-on reset (POR)
Short-circuit, overvoltage, and overtemperature protection
Internal soft start to limit inrush currents
Input-to-output isolation during faults or shutdown
Operation down to VIN = 2.5 V with undervoltage lockout (UVLO) at VIN = 2.0 V
Small lead frame chip scale package (LFCSP)
ADP8863應用:
LED indication
Funlight indicator lighting
Keypad backlighting
RGB LED color generation and mixing
General backlighting of small format displays
圖1.ADP8863詳細方框圖
圖2.ADP8863典型工作電路框圖
圖3.ADP8863采用鎮流電阻給LED供電方框圖
圖4.ADP8863連接到ADP8861,給更多LED供電方框圖
圖5.用于低Vf LED的另一種應用電路
The ADP8863 combines a powerful charge pump driver with advanced autonomous LED lighting features. It allows as many as seven LEDs to be independently driven up to 30 mA (maximum). The seventh LED can also be driven to 60 mA (maximum). All LEDs are programmable for maximum current and fade in/fade out times via the I2C interface.
Additionally, automated blinking routines can be independently programmed and enabled for all seven LED channels. These LEDs can also be combined into groups to reduce the processor instructions.
This entire configuration is driven by a two-capacitor charge pump with gains of 1×, 1.5×, and 2×. The charge pump is capable of driving a maximum IOUT of 240 mA from a supply of 2.5 V to 5.5 V. The device includes a variety of safety features including short-circuit, overvoltage, and overtemperature protection. These features allow easy implementation of a safe and robust design. Additionally, input inrush currents are limited via an integrated soft start combined with controlled input-to-output isolation.
The ADP8863 is available in a compact lead frame chip scale package (LFCSP).
ADP8863主要特性:
Automated blinking and funlight timing for each LED driver
16 programmable fade in and fade out times
0.1 sec to 5.5 sec
Selectable linear, square, or cubic fade rates
7 independent and programmable LED drivers
7 drivers capable of 30 mA (maximum)
1 driver also capable of 60 mA (maximum)
Programmable maximum current limit (128 levels)
Separate and independent controls for backlight LEDs
Backlight fade override
Up to two built-in comparator inputs with programmable modes for ambient light sensing
Charge pump with automatic gain selection of 1×, 1.5×, and 2× for maximum efficiency
Standby mode for <1 μA current consumption
I2C-compatible interface for all programming
Dedicated reset pin and built-in power-on reset (POR)
Short-circuit, overvoltage, and overtemperature protection
Internal soft start to limit inrush currents
Input-to-output isolation during faults or shutdown
Operation down to VIN = 2.5 V with undervoltage lockout (UVLO) at VIN = 2.0 V
Small lead frame chip scale package (LFCSP)
ADP8863應用:
LED indication
Funlight indicator lighting
Keypad backlighting
RGB LED color generation and mixing
General backlighting of small format displays
圖1.ADP8863詳細方框圖
圖2.ADP8863典型工作電路框圖
圖3.ADP8863采用鎮流電阻給LED供電方框圖
圖4.ADP8863連接到ADP8861,給更多LED供電方框圖
圖5.用于低Vf LED的另一種應用電路
下載文檔本站聲明： 本文章由作者或相關機構授權發布，目的在于傳遞更多信息，并不代表本站贊同其觀點，本站亦不保證或承諾內容真實性等。需要轉載請聯系該專欄作者，如若文章內容侵犯您的權益，請及時聯系本站刪除。
換一批
延伸閱讀
湖南長沙2022年9月5日 /美通社/ -- 助力低碳出行，用芯驅動未來。9月2日，湖南三安半導體主辦的2022首屆新能源汽車電驅動技術創新峰會在長沙圓滿落幕。為提升汽車供應鏈韌性，加強汽車產業生態建設，了解多方需求強化...
關鍵字： MOS 碳化硅 新能源汽車 驅動技術–研究結果表明，開發用于治療與過敏性和炎癥性皮膚疾病（包括特應性皮炎）相關瘙癢癥的CBP-174具有良好的安全性和耐受性 – 美國圣地亞哥和中國蘇州太倉2022年9月1日 /美通社/ -- 康乃德生...
關鍵字： BSP SE AD 動力學
廠商專欄
熱門文章
- 稚暉君機器人公司否認借殼上市 回應：只是收購了一家上市公司
- 尊湃芯片竊密案宣判：創始人獲刑6年，華為勝訴！
- 突發！美國科技巨頭上海AI研究院解散
- 深入解讀MOS管
- 美國服“軟”！解除EDA出口限制，芯片設計不再卡脖子
- 深度解析阻抗匹配網絡——L型、pi型與T型
- 小華四開關BUCK-BOOST參考設計助力雙向DC/DC電源開發
- 阿里最新17位合伙人名單出爐：9人退出 無新增
- CAN總線的工作原理是什么？CAN總線和LIN總線有什么區別？
- 您的低電流測量精度如何？
編輯精選
更多
論壇活動
技術子站
更多
